23  Replacing the Hard Disk Drive

The system comes with a pre-installed 3.5" SATA hard disk drive. You can replace the hard disk drive with one up to a maximum size of 8TB .

23.1  Removing the Hard Disk Drive

    To remove the hard disk drive:
  1. Power off the system, and unplug all cabling from the system.
  2. Turn the recorder over. Remove the bottom panel screws (6×).
    Graphic
  3. Turn the recorder over carefully, then remove the top panel.
  4. Gently remove the power and SATA cables from the hard disk drive.
    Graphic
  5. Carefully pick up the hard disk drive to lift the bottom panel, being mindful of the sharp edges of the bottom panel. Remove the hard disk drive screws (4×) from the bottom panel. Hold onto the hard disk drive so it remains in place when all screws have been removed.
    Graphic
  6. If you are not immediately going to install a new hard disk drive, replace the top panel and the 6 bottom panel screws.

23.2  Installing a New Hard Disk Drive

    To install a new hard disk drive:
  1. Insert the 2 hard disk drive screws closest to the SATA and power ports on the hard disk drive and tighten them half way.
    Graphic
  2. Power off the system, and unplug all cabling from the system.
  3. Turn the recorder over. Remove the bottom panel screws (6×).
    Graphic
  4. Turn the recorder over carefully, then remove the top panel.
  5. Line the 2 half-inserted hard disk drive screws with the 2 holes shown below.
    Graphic
    Graphic
  6. Carefully pick up the bottom panel with the hard disk drive, being mindful of the sharp edges of the bottom panel. Slide the 2 pre-inserted screws into the locked position, then tighten the screws. Insert and tighten the 2 remaining hard disk drive screws.
    Graphic
  7. Connect the power and SATA cables to the hard disk drive.
    Graphic
  8. Replace the top panel and the 6 bottom panel screws.