18 Sound Detection
Sound detection uses the built-in microphone to trigger recording when abnormal audio or intense sounds are detected near
the camera. Ensure that the camera is not near constant background noise that will trigger audio detection and create false
alerts.
Sound Detection is compatible with certain Lorex IP cameras. For a complete list of compatible cameras, navigate to your recorder
series at
lorex.com/compatibility
.
18.1 Configuring Sound Detection
Make sure you already have the camera audio enabled on the main and sub-stream of the channel you are configuring, see
24 Connecting Audio Devices
for details.
To configure sound detection:
-
From the Live View display, right-click to open the Quick Menu, then click Main Menu.
-
Click EVENTS. Click the Event Settings tab from the side panel, then the Sound Detection tab from the drop-down.
-
Select a compatible camera.
-
Check to enable Audio Exception to trigger the system when the audio input is abnormal.
-
Check to enable Intensity Change to trigger the system when the sound intensity exceeds the sensitivity and threshold levels.
-
Sensitivity: Adjust the sensitivity bar to increase or decrease the amount of sound required to trigger an event above the threshold.
Sensitivity is a finer setting than the threshold setting.
-
Threshold: Adjust the threshold bar to determine how loud a sound must be to trigger an audio detection event.
|
Note
|
To avoid receiving too many notifications from a noisy environment, set the Threshold level to high. The system is triggered easily when the Sensitivity level is set to high and Threshold level is set to low.
|
-
Click Setting next to Schedule to choose which days and times of the week to enable sound detection:
-
Click or click-and-drag along each of the red timelines to quickly add or remove time from each day’s schedule in 30–minute
segments.
-
Click
beside 2 or more days to link schedules (
). This allows you to quickly change multiple schedules at once.
-
To make fine adjustments to a schedule, click
. This will allow you to set exact start and end times for a schedule.
-
Choose how the system will react when there is abnormal or intense sound detection:
-
Show Message: Check to enable an on-screen pop-up when one of your cameras detects motion. On-screen pop-up shows the channels an event
occurred on and the type of event.
-
Send Email: Check to enable email alerts. You must configure email alerts before you will be able to receive them (see
21.5.3 Configuring Email Alerts
).
-
Record Channel: Select the channels that will record when motion is detected on the selected channel. Set the length of recording following
a video loss event in the Post-Record field.
-
PTZ Linkage: Set connected PTZ cameras to start a tour, pattern, or go to a preset location.
-
Sequence: Sequence mode will begin. Select the numbered tiles next to this option to include the corresponding channels in the sequence.
-
Picture Storage: Check the box to save a snapshot of the corresponding channels.
-
Buzzer: Check to enable the system buzzer.
-
Click Apply to save changes.