24 Connecting Audio Devices
The system supports Lorex HD audio cameras, which transmit audio through the same network cable used for video connection
and powering the camera. The system can also record one audio channel using the AUDIO IN port on the rear panel. You must have a self-powered microphone or an audio camera with an RCA–type audio connection to use
this port.
|
Note
|
Use of an external microphone allows you to record audio on Channel 1 of the system. It cannot be moved to a different channel.
|
The second RCA-type connector on the back panel is the AUDIO OUT port, which can be used to connect a self-powered speaker that will play audio from the system (requires audio-capable camera
or self-power microphone).
To enable audio recording:
|
CAUTION
|
Audio recording and / or use of listen-in audio without consent is illegal in certain jurisdictions. Lorex Corporation assumes
no liability for use of its products that does not conform with local laws.
|
-
From the Live View display, right-click to open the Quick Menu, then click Main Menu.
-
Click CAMERA. Click the Recording tab from the side panel, then the Recording tab from the top panel.
-
Select the channel where the audio camera is connected.
-
Select the type of recording to enable audio for. If you wish to record audio at all times, ensure you configure both General (continuous) and Motion (motion detection) recording.
-
Under Main Stream, click More and configure the following:
-
Audio: Click to enable.
-
Compression: Select an audio codec (G711a recommended).
-
Sampling Frequency: Select an audio sampling rate (8000 recommended).
-
Click Apply to save changes.